Universal Laser Systems X2-600 User's Guide download pdf (Page 79)

Link to Table of Contents

User Guide

180

Maintenance

Tilt the front cover enough to enable you to apply the lens cleaning solution directly to the #3 mirror and 3.

to the focus lens.

Flood the reective surface of the #3 mirror with the solution. If heavy debris is present, let the solution soak 4.

in for a minute.

Roll a fresh cotton swab across the mirror in one direction. Use a fresh swab for each pass. Be gentle when 5.

cleaning the optic to avoid scratching the surface. Repeat this procedure for the focus lens, but make sure

you clean both sides of the lens.

Beam Window

The beam window is where the laser beam enters into the engraving area. It is located in the upper left hand

corner of the engraving area against the back wall and is yellow in color. It is only necessary to clean the front

side of the beam window. Do not remove the optic to clean it; simply clean it in the same manner as the #2

mirror.

If your system is equipped with Air Assist, using your ngers, rotate the beam window cover counter-clockwise

(2) and then o at a 45-degree angle (3). If the beam window cover is stuck, use a 1/16 Allen wrench to loosen

or remove the screw (1) and try again. Set the cover o to the side and clean the optic, if necessary. Reinstall the

beam window cover opposite of removal, being careful not to scratch the optic.

Air Assist

1 2 ... 74 75 76 77 78 79 80 81 82 83 84 ... 118 119

No comments

Universal Laser Systems X2-600 User's Guide Page 79