Universal Laser Systems X2-600 User's Guide download pdf (Page 63)

Link to Table of Contents

User Guide

VLS3.60, VLS4.60 and VLS6.60 Accessories

To install the cone, insert the cone (1) into the cone base completely until it bottoms out. Tighten the setscrew on the

side of the cone base (2) until it is snug. To remove the cone, simply loosen the setscrew (2) and pull the cone straight

down. Do not remove or loosen the cone base mounting screws (3) & (4) to mount or dismount the cone. These screws

keep the cone base aligned with the laser beam.

CAUTION: Do not install the cone unless you plan on using Air Assist and never use the Air

Assist Cone without proper airow and air presure. Leaving the cone attached to the cone

base and running the laser system without either air or gas owing through the cone will

destroy the focus lens within a few seconds. If you are not using Air Assist, remove the

cone. Damage of this nature will not be covered under warranty.

Air Assist Cone

Power the laser system ON and start the UCP.1.

Open the top door.2.

Position the focus carriage in the middle of the eld.3.

Place a piece of paper (1) underneath the cone and observe 4.

the position of the red beam (2) in relation to the center of the

bottom of the cone (3).

If the red beam is not centered, remove and reinstall the cone.5.

If the red beam is still not centered, check all your optics for 6.

looseness or mechanical misalignment.

If still not centered, loosen the two base mounting screws (4) 7.

slightly (1/4 turn) and slide the base (5) around until the red

diode laser comes out of the centered of the cone.

Tighten the base mounting screws (4) gently and re-check the 8.

cone’s alignment.

2.0

Cone Alignment Check and Adjust

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 ... 118 119

No comments

Universal Laser Systems X2-600 User's Guide Page 63