Universal Laser Systems X2-600 User's Guide download pdf (Page 73)

Link to Table of Contents

User Guide

109

VLS3.60, VLS4.60 and VLS6.60 Accessories

Use the Focus Tool to focus on top of the at surface of the concave metal xture with the focus tool. 5. Do not

focus on top of the black metal cover that is located on the left hand side of the rotary.

After focusing is complete, click both SAVE buttons on the Rotary Calibration window. If asked to overwrite an 6.

existing position, accept the new value by clicking on YES.

Once complete, click the CLOSE button and the focus carriage will re-home once you exit the window.7.

Calibration is now complete.8.

Determining Graphic Placement

Open the top door.1.

Using the Navigation buttons on the UPC, position the Focus Carriage above the glass.2.

Stop movement where you would like the top of the graphic (the right dotted line in the 3.

engraving area) to begin. Look at the X and Y positions on the UCP and read the “X” position. Make a note of this

number.

Now, position the red dot at the lowest point (the left dotted line in the engraving area) on the glass where you 4.

would like the engraving to end. Make a note of this “X” coordinate.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24

Close all doors of the laser system, go to your computer and open your graphics software and proceed to the 5.

next page.

Now you need to determine where the engraving should appear on the glass. You can use the top ruler as a visual

aid in referencing the engraving area of the glass or you can use the Red Diode Laser and the X-Y coordinate system

to precisely place the graphic in your graphics program. To be more precise, use the Red Diode Laser Pointer.

1 2 ... 68 69 70 71 72 73 74 75 76 77 78 ... 118 119

No comments

Universal Laser Systems X2-600 User's Guide Page 73