Universal Laser Systems X2-600 User's Guide download pdf (Page 105)

Link to Table of Contents

User Guide

237

ULS Reference Guide Book

Running Your First Job

We will now illustrate how to use your laser system to engrave on a piece of anodized aluminum from start to

nish. In this example, you will raster engrave a Test Card on a 2 x 3.5 inch (50.8 x 89 mm), 0.0195 inch (0.49 mm)

thick piece of anodized aluminum.

Note: For this example we will be using CorelDRAW X3 and the CorelDRAW sample le provided on the software

CD. Install CorelDRAW, but do not start a new project.

Step 1 – Loading and Positioning the Material

Open the top door and position the piece of anodized aluminum (1) into the upper left corner of the table, against

the rulers.

Step 2 – Creating the Graphic

Using CorelDRAW, open the sample graphic le found on the software installation CD that came with the VLS

system. The le is named ULSTest.cdr. The Software Installation CD contains test les in .cdr, .eps, and .dxf.

1 2 ... 100 101 102 103 104 105 106 107 108 109 110 ... 118 119

No comments

Universal Laser Systems X2-600 User's Guide Page 105