Universal Laser Systems X2-600 Troubleshooting Guide download pdf (Page 82)

ACCESSORIES

Section 6-14

• Place the bracket on the table (1). Insert the thumbscrews and washers (2) into the screw holes but

do not tighten down completely. Leave the thumbscrews loose enough so that the bracket can slide.

20 21 22 23 24

• Place the Rotary Fixture on a flat surface. Using an Allen wrench, attach the two socket head

shoulder screws (1) to the side of the base plate.

• Place the Rotary Fixture on top of the bracket so that its pivot bolts set into the forks in the bracket.

Gently push the fixture (1) flat up against the top ruler.

NOW, tighten down the thumbscrews (2).

6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24

WARNING

TURN THE LASER SYSTEM OFF BEFORE

CONNECTING OR DISCONNECTING

THE ROTARY FIXTURE

• With the power to the system still OFF, connect the 9-pin Rotary Fixture control cable to the

receptacle on the laser engraving system (1).

READY

12 13 14 15 16 17 18 19 20 21 22 23 24

• Before loading the glass into the fixture, measure the diameter of the glass in the

area where the engraving is to be located by using a caliper or similar measuring

device. Either remember this number or write it down.

• Place the open end of the glass on the right side of the Rotary Fixture. Lift the

lever (1) on the adjustable end of the fixture and slide it up against the base of

the glass so the glass rests firmly centered inside of the inverted cone. Push the

adjustable end of the fixture (2) to the right, firmly against the bottom of the glass. Do not to apply too

much pressure, especially with glass. You only need enough pressure to prevent the object from

slipping on the cone while it rotates. Lower the lever on the end of the fixture to lock it in place.

1 2 ... 77 78 79 80 81 82 83 84

No comments

Universal Laser Systems X2-600 Troubleshooting Guide Page 82