Universal Laser Systems X2-600 Troubleshooting Guide download pdf (Page 17)

INSTALLATION

Section 2-5

Laser Cartridge Installation

Before connecting and powering on your system, you must install the laser cartridges.

1) Make sure that your power cord IS NOT plugged in at this time. Press on the backside of the two

hinges to release the latch. Gently fold back the rear cover.

2) Locate the laser mounting blocks, the laser latches, and alignment forks. Notice that the alignment

forks have two plates, one small and one large. Locate the gap between the two plates. Observe the “V”

groove along the upper and lower part of the laser cartridge and the alignment plate at the end.

3) If you have purchased two lasers, mount the first cartridge onto the LOWER mounting blocks first.

Single laser users should mount the laser in the top position. Tilt the laser cartridge downward on a 30-

degree angle. Place the upper “V” groove of the cartridge on top of the mounting blocks. Slide the

cartridge to the right until the alignment plate of the laser cartridge makes contact with the inside of the

large plate of the alignment fork. Slowly rotate the laser cartridge making sure that the alignment plate is

centered in the fork. As you slowly release the weight of the laser, you should feel it lock (clunk sound)

itself smoothly into place, parallel to the mounting surface. NEVER FORCE THE LASER INTO

POSITION. If the laser does not install smoothly, check for obstructions such as pinched wires or hoses

or a binding laser latch. Mount the second laser on the top mounts in the same manner as the bottom.

Once installed, re-verify that the alignment plates are centered within the alignment forks.

The power connectors are labeled “Top” and “Bottom”. It is very important that you plug in the correct

connector into the appropriate laser, otherwise the laser system will not function properly. The power

connectors are keyed so it will only insert one way. Single laser users should just leave the bottom

connector unplugged and out of the way. Close the rear cover slowly, making sure that you do not pinch

any wires, and push down on the latches until they “click”.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 83 84

No comments

Universal Laser Systems X2-600 Troubleshooting Guide Page 17