Universal Laser Systems X2-600 Troubleshooting Guide download pdf (Page 57)

MATERIAL SETTINGS GUIDE

Section 5-13

GLASS / CRYSTAL

RASTER ENGRAVING

LASER WATTAGE POWER SPEED PPI PASS DEPTH

25 100 13 300 1 .001

30 100 15 300 1 .001

35 100 18 300 1 .001

40 100 20 300 1 .001

45 100 23 300 1 .001

50 100 26 300 1 .001

55 100 28 300 1 .001

60 100 30 300 1 .001

COMMENTS: Engrave at Image Density 4.

VECTOR ENGRAVING

LASER WATTAGE POWER SPEED PPI PASS DEPTH

25 10 3.3 300 1 .001

30 10 4.0 300 1 .001

35 10 4.6 300 1 .001

40 10 5.3 300 1 .001

45 10 5.9 300 1 .001

50 10 6.6 300 1 .001

55 10 7.3 300 1 .001

60 10 7.9 300 1 .001

COMMENTS

Glass engraving is different from other types of engraving. A CO

laser cannot engrave into the glass nor

can it cut glass. Instead, laser interaction with glass causes the surface of the glass to appear frosted.

Sometimes, placing a piece of newspaper on the glass and dampening is with water will improve the

appearance of the engraving. Another method is to apply transfer tape to the glass, wet it with water from

a spray bottle, and laser engrave it. The transfer tape and water will act as a heat sink and pull the heat

away from the glass as the laser system engraves it. This helps reduce chipping or flaking of the glass.

Be especially careful when engraving leaded crystal. The lead in crystal conducts heat, which can cause

much more flaking or even the cracking of the crystal. Use a lower power setting to try to reduce the

chance of damage. It is always good to have at least one extra piece to use as a test piece to get the

right settings especially if you have never tried to engrave that material before.

ENGRAVING THIS MATERIAL PRODUCES ABRASIVE PARTICLES. Clean the

laser system more frequently to reduce wear and tear on the motion system

components and optics. Damage to the laser system from inadequate or insufficient

maintenance ARE NOT covered under warranty.

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 83 84

No comments

Universal Laser Systems X2-600 Troubleshooting Guide Page 57