Universal Laser Systems X2-600 Troubleshooting Guide download pdf (Page 45)

Section 5

Material Settings Guide

This section provides sample driver settings and helpful hints to get started engraving and/or

cutting the materials listed.

Safety

NEVER LEAVE THE LASER SYSTEM RUNNING UNATTENDED FOR ANY REASON. Exposure to the

laser beam can cause ignition of combustible materials. All laser cutting and engraving should be

constantly supervised.

NEVER OPERATE THE LASER SYSTEM WITHOUT A PROPERLY INSTALLED AND OPERATING

EXHAUST SYSTEM. Some materials when cut or engraved can produce fumes that are hazardous in

concentrated amounts. Also make sure that your room is adequately ventilated as some materials will

continue to produce fumes for several minutes to possibly hours after the cutting or engraving process

has been completed. Since many materials can produce toxic and possibly caustic fumes or residue, it is

advisable to obtain the Material Safety Data Sheet (MSDS) from the materials manufacturer. The MSDS

discloses all of the hazards when handling or processing that material. The law requires all

manufacturers to provide this information to anyone who requests it.

DO NOT ENGRAVE OR CUT PVC (Polyvinylchloride) BASED MATERIALS. The fumes are extremely

toxic if you inhale them. The fumes are so caustic that it can chemically destroy the metal parts of the

laser system. Damage to the laser system from this type of abuse ARE NOT covered under warranty.

DO NOT ENGRAVE OR CUT UNCOATED METALS OR REFLECTIVE SURFACES. The laser beam

can reflect off of these materials causing damage to the laser system as well as being a safety hazard.

Damage to the laser system from this type of abuse ARE NOT covered under warranty.

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 83 84

No comments

Universal Laser Systems X2-600 Troubleshooting Guide Page 45