Universal Laser Systems X-600 User's Guide download pdf (Page 9)

Description of Appropriate Use

This device is designed for laser cutting and engraving in an office, laboratory, workshop or light duty

manufacturing environment. Materials to be processed must fit completely inside the system for proper operation.

CAUTION: This device is not designed, tested, intended or authorized for use in any medical applications,

surgical applications, medical device manufacturing or any similar procedure or process requiring approval,

testing or certification by the United States Food and Drug Administration or other similar governmental

entities.

General Safety

Use of the equipment in a manner other than described in this manual or failure to follow the operational

requirements and safety guidelines listed in this manual can result in injury to yourself and others and may cause

damage to the equipment and your facility.

EXPOSURE TO THE LASER BEAM MAY CAUSE PHYSICAL BURNS AND CAN CAUSE

SEVERE EYE DAMAGE. Proper use and care of this system are essential to safe operation.

Use of controls or

adjust

ments or performance of procedures other than those specified

herein may result in hazardous

radia

tion

exposur

NEVER OPERATE THE LASER SYSTEM WITHOUT CONSTANT SUPERVISION OF THE

CUTTING AND ENGRAVING PROCESS. Exposure to the laser beam may cause ignition

combustible

mat

rials

which can lead to a

fire. A

properly

maintained

fire extinguisher

should be kept on hand at all

times

NEVER LEAVE MATERIALS IN THE LASER SYSTEM AFTER LASER PROCESSING HAS

FINISHED. Always remove all material including scrap material from the machine after

use

Scrap material left in the laser system including materials that collect in the

removable

cutting table device

can be a fire

hazar

is also

recommended

you allow

scrap

materials

to cool prior to leaving the work area. A properly

maintained

fire extinguisher should

kept on hand at all

times

A PROPERLY CONFIGURED, INSTALLED, MAINTAINED AND OPERATIONAL

PARTICULATE AND FUME EXHAUST SYSTEM IS MANDATORY WHEN OPERATING THE

LASER SYSTEM. Fumes

and

smoke from the engraving process must be extracted from

the laser system and filtered or

exhausted outside

SOME MATERIALS, WHEN ENGRAVED OR CUT WITH A LASER, CAN PRODUCE

TOXIC AND CORROSIVE FUMES. We

recommend

that you obtain the Material Safety

Data Sheet

(MSDS)

the manufacturer of every material you intent to process in the

laser system

MSDS

discloses all of the hazards when handling

processing a

particular

mat

rial

DISCONTINUE processing any material that causes

chemical

deterioration

of the laser system such as rust, metal etching or

pitting

peeling paint,

Damage

the laser system from corrosive fumes is NOT covered under

warrant

DO NOT ATTEMPT TO MOVE OR LIFT THIS SYSTEM ALONE. Obtain the assistance of

additional people when lifting or carrying (secure motion system and doors before lifting).

Injury may occur

improper lifting

techniques

are used or the system is

opped

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 68 69

Comments to this Manuals

No comments

Universal Laser Systems X-600 User's Guide Page 9

Comments to this Manuals

Related products and manuals for Engraver Universal Laser Systems X-600