Universal Laser Systems X-600 User's Guide download pdf (Page 51)

Cutting Table

The cutting table is used to support material when cutting so that exhaust flow is redirected both above and below

the material for clean cuts. Without it, smoke and debris can build up underneath the material causing the surface

of the material to be damaged. The cutting table also helps to reduce damage to the surface of the material from

laser back reflection which can occur when the laser reflects off of the table supporting the material if you attempt

to cut without the cutting table.

Installation

1. Turn on your laser system.

2. Lower the engraving table to the bottom of its travel.

3. Remove the engraving table by loosening the two captive thumbscrews (1). Then, using the finger holes

(2), carefully lift the table out of the laser system.

4. The table support platform underneath contains a self-aligning electrical connector (1) and the two

alignment pins (2).

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 68 69

No comments

Universal Laser Systems X-600 User's Guide Page 51