Universal Laser Systems X2-600 Specifications download pdf (Page 54)

A38

LASER TRANSMITTER D22, D23 and D75: tilting screws

The tilting screws on the levelling table of the

D22 and D23 lasertransmitter, and on the D75

transmitter have to be operated carefully and

according to instructions on this page.

Visual rough alignment to (detector) target

Check the position of the fine adjustment screw (C). It

should be in its nominal position appr. 2.5 mm according to

the figure (Fig. 2).

1. Loosen the locking screw (A)

2. Adjust with the course screw (B) to wanted position.

3. Tighten the locking screw (A)

Digital fine adjustment to detector and read values

Important! The fine adjustment screw (C) must not exceed

its upper (Max.) position (Fig. 3). That might damage the

threads of the screw.

1. Check so that the locking screw (A) is tightened.

2. Adjust with the fine adjustment screw (C) to wanted value.

Fig. 1

Fig. 3. Maximal adjustment

Max. 5.5 mm

Fig. 2. Nominal position

2.5 mm

Fine (C)

Course (B)

Locking (A)

1 2 ... 49 50 51 52 53 54

No comments

Universal Laser Systems X2-600 Specifications Page 54