Universal Laser Systems X-600 Troubleshooting Guide download pdf (Page 31)

OPERATION AND PRINTER DRIVER CONTROLS

Section 3-6

Clear Cache

Yes / No: Permanently deletes ALL stored jobs from system hard drive.

Screen Saver

Sets delay in screen saver on time.

Align Camera (Optional)

Used for calibrating offset from center of focus lens to center of camera.

1. Focus on material.

2. Press

/ / Align Camera / .

3. Place material in lower right corner.

4. Press

OK, a cross hair will be engraved. DO NOT MOVE MATERIAL.

5. After cross hair appears scroll down to ALIGN CROSS HAIR, press

6. Wait 5 seconds then move arm by hand. Align cross hair over marked cross hair.

7. Press

to save.

8. Offset will appear.

9. Press

to quit.

Home XY Axis

Homes motion in both the X and Y axis.

Home Z Axis

Homes Z table by lowering table to the bottom sensor.

Detect Collision

No / Yes: When enabled anything protruding above the focal plane will cause collision sensors to stop

motion.

Allow Auto Focus

Yes / No: Allows the use of sensor to set focal height.

1. Press

focus mode.

2. Wait 10 seconds.

3. Move carriage over object to be engraved using your hand.

4. Press

focus a 2

time.

5. You will be asked if you would like to SET FOCUS, press

for yes.

Set Lens Focus

Set Z height for use with Auto Z.

1. Remove all objects from underneath the Z axis table.

2. Scroll down to Home Z Axis, then press

. Z table will lower to bottom sensor.

3. Press

to return to the motion menu, press again to toggle to Z Axis.

4. Using the arrow keys

focus to the top of the table using the appropriate focus tool.

5. Scroll down to SET LENS FOCUS, choose yes.

6. Z axis will now read 0 on the display.

Diagnostics (This section used for service only)

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 73 74

Comments to this Manuals

No comments

Universal Laser Systems X-600 Troubleshooting Guide Page 31

Comments to this Manuals

Related products and manuals for Engraver Universal Laser Systems X-600